Logo

B3298 Engine Trouble Code

Meaning of B3298 engine trouble code is a kind of body trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $200-$300 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

B3298 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for B3298 code is occuring now you should check B3298 repair processes.
Now don't ask yourself; What should you do with B3298 code ?
The solution is here :

B3298 Possible Solution:

B3298 Engine

Power Steering Pressure (PSP) Switch Malfunction In Key On, Engine Off Self-Test, this DTC indicates the PSP input to the PCM is high. In Key On, Engine Running Self-Test, this DTC indicates that the PSP input did not change state. Steering wheel must be turned during Key On, Engine Running Self-Test PSP switch/shorting bar damaged SIG RTN circuit open PSP circuit open or shorted to SIGRTN PCM damaged.

B3298 Code Meaning :

B 3 2 9 8
OBD-II Diagnostic Body (B) Trouble Code For Engine Ignition System Or Misfire Manifold Absolute Pressure/Barometric Pressure Circuit High Input Crankshaft Position Sensor A Circuit Malfunction Clutch Position Sensor Circuit Malfunction

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

B3298 OBD-II Diagnostic Body (B) Trouble Code Description

B3298 engine trouble code is about Clutch Position Sensor Circuit Malfunction.

Main reason For B3298 Code

The reason of B3298 OBD-II Engine Trouble Code is Manifold Absolute Pressure/Barometric Pressure Circuit High Input.

B3298 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.